01/6/23
 |
I sprayed yellow color to the body again (This is thrid time!),I have the airconditioner cool on full blast.
Dehumidification is the most important part of spraying models in the rainy season. |
 |
You can use the mirror just as it is , but dig it out and fill in a sharpend nickel-silver-plate will make it better looking. |
 |
Left : the mirror has digged out.
Right : just as it is. This is the limit of close up picture of my digital camera! |
 |
Before spraying , I drilled and put a handle by blass stick.
Then spray from surfacer ,white and yellow. |
 |
This is a rear fuel cap.
Sharpened it up so that it loos like a real car. Spray metal-primer so as not to be clouded. Uhmmmm,my eyes are now getting tired・・・ Keep these small parts clipped so as not to be flew. |
 |
Wheel
Silver is specified ,but Ipicked gun-metal-color. (Later I sprayed polished-aluminium-color again・・・・(^_^;)) |
01/7/1
I caught a terrible cold , because of the full blasting airconditioner・・・・
 |
I sprayed clear-color.
Keep it dry at least a week. |
01/7/8
 |
Look this! How is it ?
I just sprayed and dried enough. Use #2000 sanding-paper to sharpen the edges and polished with polishing powder. |
01/7/9
 |
I sprayed flat-black after masking beneath of the body.
As usual ,the pace of making models slow down when I get to this step・・・・ not good habit isn't it? |
01/10/8
 |
I've left this as it was....as I thought .
Luckily , I could erase the differense of chaps which appeared on fhe roof. Then , I sprayed inside of the car. I use mask-sol for the frame of windows. |
 |
Now I came to the biggest hurdle of the BBR kit. ("Frame of the windows" this is a barrier of the BBR kit.) First , tie up the center of flames with masking tapes on transparent films. Then bend the films a little bit ,put a little bit of konishi-bond(G-clear) which is putted by a point of a needle,return the film as it were and keep it tied up for half of a day with small pieces of masking tapes. I've laid out papers so as not make scars on the films. If you fail , you can peel off by paint-thiner and start it over.(I've done this too...) Even you were out of the transparent films ,you can substitute the films of celluloid-fims(use animation) tor these. |